Faber MatriX 800/400 I, Руководство пользователя

Страница: 11 / 12

User manual MatriX I.T.C. Honeywell
11 < < < <
Calibration
At calibration you have the opportunity to sync
temperature measurement of the I.T.C. with your
own home thermostat. You indicate at this setting
how much the temperature of the I.T.C. deviates
from your own home thermostat. It is important
that the remote control is located in its cradle in
the specified location. (See chapter 8).
Adjust the value only after the thermostat has had
a few hours to adjust to the ambient temperature.
Reset function
Reset I.T.C./automatic burner
In the unlikely event that your fire crashed due to a
software failure, you can fully reset the I.T.C and
automatic burner with this function.

Please note!
This is not possible when the fire is blocked by
the I.T.C for safety reasons.
Reset user settings
Here you can reset your personal settings to the
factory default settings.
Empty memory and disconnect all
connections (remote control and
Smartphone / Tablet)
Press for about 30 seconds on the controller
coupler, see fig. 1.5 (this is located behind the
small service door). The LED changes from blue to
light blue. Release the button and then briefly
press the pairing button again. All connections
have now been erased from the memory. In order
to operate the fireplace, the remote control must
be connected again (see section 4.1). To reconnect
the Smartphone / Tablet, see section 5.1.
Register
The I.T.C. records the number of usage and stand-
by hours plus energy consumption. The I.T.C. also
calculates the maintenance period based on this
data.
The calculated gas consumption is a good
approximation.
The I.T.C. also registers the nature and the number
of malfunctions.
Statistics
If you are connected with your fire, go to Menu
(top left) and select "Statistics". In the screen you
can now choose from energy consumption or the
number of hours the fireplace has been burning.
Here you can read how many m³ gas or kWh of
electricity per day, month or year was consumed.
Wall mount remote control
For proper operation of the thermostat and ECO
function, it is necessary to hang the remote control
in the holder (see fig. 1.7) in a suitable location.
The remote control is also the room temperature
sensor. Place the holder at a height of about 1.5 m
and out of the radiation area of the fireplace.
Avoid placement in corners, near windows, doors
and heat sources such as central heating radiators.