Faber MatriX 450/500 III, Руководство по установке

Страница: 11 / 32

Installation manual Matrix 450/500 III and MatriX 450/650 III
11 < < < <
4 Preparation and installation instruc-
tions
4.1 Gas connection
The gas connection must comply with the applica-
ble local standards.

Please note!

Provide a flexible gas connection with at
least 0,5m extra length, so that the con-
trol unit can be removed for installation
and service!

Calculate the gas pipe so that no pres-
sure drop occurs.
We advise using a gas connection directly from the
gas meter to the appliance, with a shut-off valve in
the proximity of the appliance, which must always
be freely accessible. Position the gas connection so
that it is easily accessible for service and the
burner unit can be disassembled at any time.
4.2 Electrical connection
Install a 230VAC/50Hz wall socket near the fire-
place for connecting the control unit.
See fig. 2.8 for the wiring diagram:
A= Adapter (6V)
B = 2nd thermocouple
C = Receiver
D = LED Symbio module (optional)
E = Gas valve
F = Solenoid valve
See fig. 2.9 for the wiring diagram with I.T.C. (Op-
tional):
A= Adapter (6V)
B = 2nd thermocouple
C = Receiver
D = LED Symbio module (optional)
E = Gas valve
F = Solenoid valve
G = I.T.C. (optional)
4.3 Smart Home installation

Please note
This is only possible if the fire is equipped
with I.T.C!
The controller can be connected to an external
source, such as a Domotica system, by using a Fa-
ber Interface Unit (article number A9323000).
4.4 Preparing the fireplace

Remove the fireplace from its packaging.
Ensure that the gas supply pipes under
the appliance are not damaged.

Remove the glass and any mouldings,
store them at a safe place and remove the
packaged parts from the fireplace.

Prepare the gas connection on the gas
valve.
4.5 Positioning the fireplace
Take into account the installation requirements
(see chapter 3). Place the fireplace at the right
place and level it.
Rough height adjustment:

With the adjustable (optional) legs.
Accurate height adjustment:

With the adjustable feet.
Hanging on the wall
The fireplace can also be mounted on the wall us-
ing the optional wall bracket set, see Appendix
17.3 (article number A9323296). Therefore, re-
move the existing fittings and use the provided
spacer for vertical alignment, see fig. 1.3.
4.6 Installing the flue pipes
Install the flue pipes according to the installation
manual supplied with the appliance (article num-
ber 40011968)!

The distance to combustible materials
must be min. 50mm, calculated from the
outside of the flue pipe.

Never start immediately with length-ad-
justable concentric flue pipe on the appli-
ance.

Horizontal sections should be installed to
allow a slope towards the appliance (3
degrees).

Built the system from the appliance. If this
is not possible you can make use of an ex-
tendable adapter section.

For fitting of the flue system, the 0,5m
length-adjustable pipe must be used.
Make sure that the inner pipe is always
15mm longer than the outer pipe. Wall-
and roof terminal can also be cut. These
components must be secured with a self-
tapping screw.
4.7 Constructing the false chimney
Before positioning the false chimney, we advise to
perform a functional test with the fireplace as de-
fined in chapter 7 “Checking the installation”.