EN
9
9
Mounting the hood body
• Remove the metal grease filters by turning the handles pro-
vided.
• Adjust the two screws
Vr
, on brackets
11a
, to a minimum.
• Hook the hood canopy onto the two brackets
11a.
• From inside the hood canopy, adjust the screws
Vr
to set the
Hood Canopy level.
• Tighten the safety screws
12a
.
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the
chimney using either a flexible or rigid pipe ø 150 or 120 mm,
the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection, insert the re-
ducer flange
9
on the hood body outlet.
• Fix the pipe in position using sufficient pipe clamps (not sup-
plied).
• Remove possible charcoal filters.
ø 150
9
ø 120
AIR OUTLET – RECIRCULATION VERSION
• Unfasten the 2 screws fixing the upper bracket
7.2.1
.
• Fasten the air outlet connector
15
in its place, using the 2
screws removed as above.
• Join the Connector
15
to the Hood canopy outlet using a rigid
or flexible pipe ø150 mm, selection of which is at the
discretion of the installation technician.
• Make sure that the Activated charcoal odour filter has been
fitted.