Special caution: If the cooker is built with advanced flame out protection device, please adjust the air
plate until the flame-lift eliminated, the thermo couple beside the brass lid well heated and electric
current produced, so that the solenoid valve can work properly. Ensure a continuous combustion
formed before releasing your hand from the knob.
Caution for safety
Make sure gas used is identical to the type as specified on the brand plate. Other type is prohibited
to be used.
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure)
and the adjustment of the appliance are compatible.
The adjustment conditions for this appliance are stated on the label (or data plate).
This appliance is not connected to a combustion products evacuation device. It shall be installed
and connected in accordance with current installation regulations. Particular attention shall be
given to the relevant requirements regarding ventilation.
The gas cooker is designed for cooking and water boiling purpose. To avoid accident, do not allow
for towel or clothes to be dried on the gas cooker.
Keep the kitchen well ventilated and don’t put the gas cooker under strong blowing.
Avoid rubber gas tube from touching the surface of the gas cooker.
The type of gas tube should be oil-proof, heat and corrosion resistant, such as NBR.
Replace the aged gas tub timely to prevent from accident caused by gas leakage.
Ensure the gas cooker is looked after when in use, turn it off when going out or going to bed.
When gas leakage found. Immediately turn off the gas supply and open the doors and windows to
ventilate the room, Don ’ t turn on or turn off any electric switches before the gas completely
dispersed out of the room.
Keep hands off while gas cooker is in use or at the moment of unexpected flame out, since the
burner, lid and pan support are still hot.
In case cooking stuff overflow over burner, lid or water collector, clean them in time so that the gas
cooker can work properly.
Take special care: when artificial gas applied, clean the lids, flame holes, switch nozzles and gas
passage regularly(usually once a month) to remove the sediment of carbon and contamination,
which will make as way through and combustion steady.
Qualified gas regulator must be used
.
Features and characteristic
Japan-made thickened stainless steel panel or heat-resistant Teflon coated steel panel with shiny,
corrosion resistant and anti-abrading surface.
