Version 05/11 - Page 4
TOOLS NEEDED FOR INSTALLATION
• Saber Saw or Jig Saw
• Drill
• 1 1/4" Wood Drill Bit
• Pliers
• Phillips Screwdriver
• Flat Blade Screwdriver
• Wire Stripper or Utility Knife
• Metal Snips
• Measuring Tape or Ruler
• Level
• Pencil
• Caulking Gun
• Duct Tape
PARTS SUPPLIED FOR INSTALLATION
• 1 Hardware Package
• 1 Literature Package
PARTS NEEDED FOR INSTALLATION
• 2 Conduit Connectors
• Power Supply Cable
• 1 Wall or Roof Cap
• All Metal Ductwork
OPTIONAL ACCESSORIES AVAILABLE
•
High Ceiling Chimney Kit
Extends the island chimney for high
ceilings
part # HIGHFORTIS - Stainless
10" round Duct Transition Kit
Order Part Number # TRNSPRO
UNPACK THE RANGE HOOD
Remove the Range Hood from the carton and place on a flat surface for assembly. Before discarding the packaging, check to
make sure that no mounting hardware or parts are missing. DO NOT REMOVE THE PLASTIC COVERING ON THE CHIMNEYS
AT THIS TIME! This plastic covering protects the chimney from scratches during installation.
CALCULATE THE DUCTRUN LENGTH
The ductrun should not exceed 35 equivalent
feet if ducted with the required minimum of 6"
round duct. Calculate the length of the ductwork
by adding the equivalent feet in
FIGURE 2
for
each piece of duct in the system. An example
is given in
FIGURE 3
.
For best results, use no more than three 90°
elbows. Make sure that there is a minimum
of 24" of straight duct between elbows if
more than one is used. Do not install two
elbows together. If you must elbow right
away, do it as far away from the hood's
exhaust opening as possible.
9 Feet Straight Duct
2 - 90˚ Elbows
Wall Cap
Total System
FIGURE 3
3.0 feet
5.0 feet
12.0 feet
0.0 feet
45˚ Elbow
90˚ Elbow
90˚ Flat Elbow
Wall Cap
FIGURE 2
9.0 feet
10.0 feet
0.0 feet
19.0 feet
PREPARING TO ATTACH THE CHIMNEY
The Range Hood attaches to the ceiling by
a metal support structure. This support must
be attached to the ceiling before the canopy
is attached. This structure must be firmly
attached to the ceiling.
FOR WOOD CEILINGS:
Use four 4" long
wood bolts.
FOR PLASTER OR SHEET ROCK CEILINGS:
If possible, the support must be attached to
the ceiling joists. If not, a supporting structure
behind the sheet rock must be built.
• Hood canopy assembly with ventilator and light bulbs
installed
• 3 Filters (4 filters for 48" hood)
• Chimney assembly
• Ceiling mounting template
• Upper chimney cover
• Lower chimney cover
• Parts bag containing:
• Damper (2 dampers for 48" hood)
• 4 Hex washer head bolts (for attaching canopy to
chimney support)
• 4 Hex washer head wood bolts (for attaching
chimney support to ceiling)
Parts supplied in range hood package
:
WARNING!
BEFORE MAKING ANY CUTS OR HOLES FOR INSTALLATION,
DETERMINE WHICH VENTING METHOD WILL BE USED AND CAREFULLY
CALCULATE ALL MEASUREMENTS.
PRODUCT DIMENSIONS
