Faber BF110V/Straight, Руководство по установке и инструкция пользователя

Страница: 47 / 52

UK/IRL
> > > > 47
- Failure in the pilot flame system.
Contact a qualified installer when the appliance goes off regularly.
10.4 Remote control version
The remote control is only meant to regulate the flames from ‘off’ till ‘max.’. It functions
only when the pilot burner is ignited and knob A is in (big flame) position. It is therefore
not possible to ignite or extinguish the pilot flame with the remote control.
Note: The radio-frequency remote control is intended for fireplaces installed in a
domestic setting in all EU countries except Austria, Denmark, Finland, and Greece.
Features:
ƒ
Manual control will always remain possible;
ƒ
The remote control is a radio frequency type and had been approved
internationally;
ƒ
The remote control generates a unique safety code every time you activate the
transmitter, its similar to those used in a car;
ƒ
The remote control is easy to install retrospectively.
10.4.1 Using the remote control
1. Light the appliance as described in 10.2;
2. Set the on/off switch on the receiver to "on” and control the flames:
ƒ Low flame
ƒ High flame
3. Use (high) and (low) to achieve the desired heating and flame effect;
4.
You will hear a beep every time the receiver recognises a signal. (If not, see 10.4.3,
setting the right transmission code);
5.
When the fire is not be used for a prolonged period, turn off the pilot (see 10.4.2). If
the appliance is not used for an extensive period of time, it can be necessary to set
the right transmission code again.