Installation Instructions
Dodge 1500 Premium Front Bumper
Product Number: F2950, F2951, F2952
Application: 2013-2018 Dodge 1500
Copyright 2008 Fab Fours, Inc.
Page 9 of 21
F295X_REV_A
J. Remove OEM electrical harness from bumper. Disconnect harnesses from fog lights
and sensors. Sensors can be disconnected from housing by depressing the plastic clip
indicated by the red square (ref. Figure 8a).
Figure 8a
K. Pop out plastic clips holding harnesses to bumper on both sides and carefully pull
away.
L.
CAREFULLY
remove sensors from plastic housing by gently pulling the top and
bottom tabs, indicated by blue circles (Ref. Figure 8a), away as sensor is pulled out.
Do not push on front of sensor
as this will damage the membrane
. Place sensors
face up in a safe location.
M. Remove plastic housing from OEM bumper by depressing the four plastic tabs
around the inside and pushing housing out.
All sensor housings will have to be
placed into the Fab Fours bumper in the same location as they were removed
from OE bumper. (e.g. Outer right sensor clip must go into the outer right
sensor hole in the Fab Fours bumper.)
