FAAC XKPR125, Руководство пользователя

Страница: 14 / 44

XKPR / XTRR 14 532267 - Rev.B
2. XKPR/XTRR
The XKPR/XTRR reader is included in the FAAC range of access control devices.
The XKPR allows a tag to be read or numeric codes to be entered that are restricted to each user. The XTRR
allows a tag to be read. In order to be valid, each user code must be stored on the Door Controller.
!
- In order to restrict access, it is important not to allow the stored codes to be known by unau-
thorised persons. Whenever the user is given a code, one should recommend that he/she keeps
it confidential.
The XKPR/XTRR must be connected to a DOOR Controller in order to work.
3. USAGE
!
The user must follow the safety instructions and recommendations given by the installer.
In order to restrict access, the user must not give his code to other people.
L L
XKPR : Always press one button at a time (if 2 buttons are pressed at the same time, neither is
recognised). The timeout between the pressing one button and another is 5 s.
The installer must provide users with information for use.
Blind and Visually Impaired Users : these users can recognise buttons using Braille.
Warnings XKPR/XTRR
Green Buzzer Red

(OK)

1.0 s 2


(error) 1

0.5 s

EN Translation of the original instructions
1. INSTALLATION
!
The support surface must be flat and smooth. The IP sealing gaskets must be present and intact
in the base (
 1
) and in the body (
 5
).
1. Prepare the connecting cables and install the base. Follow the instructions given in
 1
.
2. Connect the XKPR/XTRR to the SPINet terminals of the Door Controller board. Follow the instructions
given in
 2
and
 3
.
-
Remove at least 1 cm of the conducting sheath. Only the conductors and
not
the sheath must be
present in the
IP
gaskets.
Otherwise, the IP gasket will leak.
- Wires having a maximum section of 0.5mm
2
can be placed in the connector on the XKPR/XTRR
3. Configure the jumper according to the type of reader, A or B. (
 4
).
4. Turn power on to the board:
- The XKPR/XTRR lights up after a few seconds.
5. Make sure that the (XKPR keypad and the proximity sensor) (XTRR proximity sensor) are working correctly.
6. Fasten the body to the base (
 5
).
7.
Install the cover (
 6
) For the XKPR/XTRR1356 models, make sure that the parts of the cover, separated
by the cut, do not touch each other after the screws have been tightened (as shown in
 7
).
!
Close or open the reader in the absence of power!