![background image](http://html1.mh-extra.com/html/faac/safe-zone-s418/safe-zone-s418_user-manual_3098269012.webp)
12
FAAC Model S418 Swing Gate Operator
Fig. 24
Fig. 23
5.1
RESTORING NORMAL OPERATION
To restore normal operation mode, proceed as follows:
1. Ensure that the system is not powered.
2. Turn the release key clockwise until it stops, Figure
24 Ref. 1, and remove the key, Figure 24 Ref.
2. The locking position is indicated by a closed
padlock.
3. Close the protective cap, Figure 24 Ref. 3.
4. Manually move the leaf until the device engages
and the leaf locks.
5. Power up the system and perform several open/
close operations to check that all functions of the
automated system have been restored.
During the first cycle, the operator might not slow
down correctly. However, wait for the end of the cycle
and then give the opening command once again.
6. MAINTENANCE
In order to ensure correct operation and constant
safety over time, make a general check of the sys-
tem every six months, paying special attention to the
safety devices.
7. REPAIRS
The user must not carry out any repairs or mainte-
nance operations; these must be performed only
and exclusively by qualified FAAC personnel or
FAAC service centers.
To keep the operator in manual mode, the release
device must be left in its current (unlocked) position and
the system must not be powered.