![background image](http://html1.mh-extra.com/html/faac/safe-zone-s418/safe-zone-s418_user-manual_3098269011.webp)
11
FAAC Model S418 Swing Gate Operator
Fig. 19
Fig. 20
Fig. 21
Fig. 22
5. Tighten the securing screw once again.
The mechanical stop is coupled to a toothed
sector, Figure 19 Ref. 2.
In the case of obstructions during movement,
check that the coupling is free. DO NOT FORCE
IT.
4. Move the mechanical stop until it is close to the
front fitting, as indicated in Figure 20.
3.6.2 Mechanical Stop at Closing
1. Prepare the operator for manual operation, see
Section 5.
2. Manually move the leaf into its closing position.
3. Loosen the securing screw, Figure 21 Ref. 1. The
screw does not need to be completely removed.
4. Move the mechanical stop until it is close to the
front fitting, as indicated in Figure 22.
5. Tighten the securing screw once again.
The mechanical stop is coupled to a toothed
sector, Figure 21 Ref. 2.
In the case of obstructions during movement,
check that the coupling is free.
DO NOT FORCE IT.
•
Once all necessary electrical connections have
been made, power up the system and program
the control unit based on your individual needs
(see relevant instructions).
•
Perform a test of the automated system and of all
connected accessories, paying special attention
to safety devices.
4.
AUTOMATED SYSTEM TEST
If the automated system needs to be moved manually,
due to a power outage or operator malfunction, perform
the following steps to release the device:
1. Switch off the power supply to the system.
2. Slide off the protective cap, Figure 23 Ref. 1.
3. Insert the supplied release key, Figure 23 Ref. 2,
and turn it counter-clockwise until it stops, Figure
23 Ref. 3. The release position is indicated by
an open padlock.
4. Move the leaf manually.
5.
MANUAL OPERATION