Estate Slide E-SL 1200
Power
1.
The Estate Slide comes with 1) AC Transformer or a solar panel. You may locate the transformer up to
1000’
aware from the control board with 16 gauge or larger direct burial low voltage wire. Allow a minimum of
4’ of wire between the control board and the transformer
.
2.
Insert the two wires into the power
-
in section on the control board (J2) on the master board. If using transformer
there is no polarity, but if using solar, positive is on top.
Do not splice the power cable wire
.
Never run 110V AC power directly to the Estate Swing. This will destroy the Estate Slide
control board.
3.
Before plugging in your transformer, plug the battery into the control board. The clear plastic clip gets clipped into
J4 with the clip side on the left. The other side of the battery wire has a clear plastic disconnect that slides on the
battery terminals. Red to Red, Black to Black.
Reversing the wires will blow the fuse
.
Never connect the power wire with the transformer plugged in. Contact between the two lead wires, even for a
second, will destroy the transformer.
4.
Plug the
transformer
into a 110V
AC outlet.
5.
The transformer is not weather
proof and must be kept in a cov-
ered area. Plug covers are avail-
able from your dealer, contact 1
-
800
-
640
-
GATE for a dealer in
your area.
6.
The power light (P) will be on if
the power and battery are con-
nected properly. If the power
light is blinking slowly then only
the battery is connected, check
your power connections.
8.1