E145
21
732784 - Rev. A
ENGLISH
Display
Basic Function
Default
F1
MOTOR 1 POWER:
You can adjust the maximum power of motor 1, which is the same during
both opening and closing.
01
= minimum power
50
= maximum power
If the power is modified, we recommend performing a new SETUP
- see the related paragraph.
If hydraulic motors are used, power must be programmed to maximum
level
(
50
).
25
F2
MOTOR 2 POWER (visualised only with the function
Mn
=
2
):
You can adjust the maximum power of motor 2, which is the same during
both opening and closing.
01
= minimum power
50
= maximum power
If the power is modified, we recommend performing a new SETUP
- see the related paragraph.
If hydraulic motors are used, power must be programmed to maximum
level
(
50
).
25
En
ENCODER USE:
You can enable/disable the use of encoders
(both BUS and GATECODER
encoders)
:
Y
= encoders on both motors
no
= encoders disabled
no
FA
LIMIT SWITCH WHEN OPENING (displayed only if function
CF
=
1
or
CF
=
PC
):
Lets you set or disable use of the opening limit switch on swing-leaves .
In case of mixed configuration (
CF
=
PC
) this function works only
o
n t
he
swing-leaves
. The limit switch on the SLIDING leaf is required
and determines when the leaf stops.
no
= opening limit switches disabled
01
= the limit switch determines the stopping of motion
02
= the limit switch determines the start of deceleration
After having changed the value of this function, SETUP is required:
the card will signal error
14
(configuration error) until the SETUP is
performed again or until the previous value is restored
no
