3 0
B614 28
732998 - Rev.A
45°
!
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
5.6 ACCESSORIES ON THE BEAM
!
The accessories on the beam must be considered
when choosing the balancer spring (single or double).
The accessories on the beam must be fitted before
balancing the beam. If the accessories are added
or removed later it may be necessary to change
the spring. After a modification of the beam, it is
necessary to balance it again.
The spring appropriate for the configuration and
length of the beam is defined in the balancing charts
(see
).
L
i
See § 9 for fitting accessories to the beam.
5.7 BALANCING THE BEAM
RISKS
PERSONAL PROTECTIVE EQUIPMENT
!
This phase requires the release of the barrier.
- Performing the release manoeuvre when there is
no electrical power.
- Keep away from the moving elements inside the
box and from the coil spires.
- Do not leave the beam vertical when the barrier
is unlocked.
L
i
See the specific instructions for balancing a jointed
beam.
1. Perform the release manoeuvre.
2. Bring the beam to 45° and release it: the beam is
balanced correctly when it stays in position.
3. Make the adjustment, if necessary:
-
if the beam wants to open, the turnbuckle must
be extended
-
if the beam wants to close, the turnbuckle must
be shortened
4. Repeat the adjustment until it is correctly balanced.
5. Restore the automatic operation.
