![background image](http://html1.mh-extra.com/html/faac/a140-air-series/a140-air-series_manual_3118617029.webp)
27
A
B
A
B
ENGLISH
15A FITTING THE MOTOR LOCK
We recommend you perform the electrical connection of the motor lock to the E140 board before fitting it on the motor.
Consult these instructions in the section concerning the control board connections in order to perform the wiring.
Fit the motor lock inserting the motor pin into the slot of the motor block as shown in figure 45 ref. A e B
Fit the motor lock inserting the motor pin into the slot of the motor block as shown in figure 45 ref. A e B
Important
: Note for the motor lock disassembly
Pay attention when working on the motor retaining tooth in order to avoid breakages: lever with a flat-tip
screwdriver between retaining tooth and motor lock fig. 45 Ref.
fig. 46
fig. 45
The motor locking device guarantees that the leaves are locked
when closed. If requested when ordering, the motor locking
device is supplied pre-installed on the support profile of the
automated system and includes the knob operated internal
release system.
Adjustment procedure for the motor locking device:
• Close the leaves.
• Manually push the lever (fig.46 ref.
) toward the motor shaft,
checking correct coupling as shown in fig. 46, ref.A).
• Move the lever (fig.46 ref.
) vertically and look for any play
between the motor shaft and motor lock coupling.
If there is no play, proceed as follows:
•Loosen the two screws (fig.46 ref B
) which connect the belt fit-
ting to the drive carriage (on both carriages for double leaves).
•Gently move the belt coupling horizontally, until the lever moves
freely; tighten the screws you had loosened.
.
15.1A ADJUSTING THE MOTOR LOCK
Содержание A140 AIR Series
