![background image](http://html.mh-extra.com/html/faac/402/402_installation-manual_535317008.webp)
7
Fig. 14
Fig. 13
6.
AUTOMATED SYSTEM TEST
When you have finished installing, apply the danger signal sticker
on the side of the operator so that it is clearly visible (Fig.14).
Run an accurate functional check of the automated system and
of all the accessories connected to it, especially the safety devices.
Hand the “User’s Guide” to the Client, explain correct operation
and use of the operator, and indicate the potentially dangerous
areas of the automated system.
7.
MANUAL OPERATION
If the gate has to be moved manually due to a power cut or fault
of the automated system, use the release device as follows:
- Insert the triangular key on the release screw located in the lower
part of the flange (Fig.15).
- Turn the release key anti-clockwise for about two turns.
- Open or close the leaf manually.
Fig. 15
8.
RESTORING NORMAL OPERATION MODE
To prevent an involuntary pulse from activating the operator during
the manoeuvre, cut power to the system before re-locking the
operator.
- To re-lock the operator, turn the key clockwise until it stops (Fig.
15).
- Lastly, remove the key and restore the power supply to the system.
9.
MAINTENANCE
Run a functional check of the system at least every 6 months, with
special attention to the efficiency of the safety and release devices
(Including the thrust force of the operator), and to perfect
operation of the gate hinges.
Also, periodically check quantity of oil inside the tank.
Oil level check instructions:
- Cut power to the system.
- Release the operator from the front and rear attachments.
- Position the operator vertically, with the rear flange high up.
- Remove the oil filling plug.
- Insert a screwdriver until it comes into contact with the electric
motor as shown in Fig. 16.
- Remove the screwdriver and check oil level as shown in Fig. 16.
USE ONLY FAAC HP FLUID OIL
Periodically check correct adjustment of the anti-crushing safety
device (BY-PASS) and the efficiency of the release system to allow
manual operation (see relevant paragraph).
The safety devices installed on the system must be checked every
6 months.
Fig. 16
10. REPAIRS
For any repairs, contact FAAC’s authorised Repair Centres.
UNLOCK
LOCK
5.
FINAL OPERATIONS
Finish the installation operations as follows:
- Remove the breather screw (Fig.13, ref.
)
Содержание 402
Страница 1: ...Leading the way Installation Manual 402 Leading the way Leading the way Swing Gate System ...
Страница 12: ......