![background image](http://html.mh-extra.com/html/faac/402/402_installation-manual_535317006.webp)
5
2)
Secure the operator to the rear attachment with the
supplied screws (Fig. 6), taking care to position the operator
with the BY-PASS screws facing up and the consequent
RELEASE screw facing the ground.
3)
Release the operator (see chapter 7).
4)
Fully remove the rod to its stop point and make it recede
by about 5 mm (Fig.7).
5)
Relock the operator (see chapter 8).
6)
Fit the front attachment onto the rod (Fig. 8)
7)
Close the gate leaf and, keeping the operator perfectly
horizontal, find the position of the front attachment (Fig. 9)
on the leaf.
8)
Provisionally fix the front attachment on the leaf with two
weld spots, protecting the rod against any welding waste.
If the gate structure does not permit the
attachment to be firmly fastened, take action on
the structure, creating a solid support base.
9)
Release the operator and manually check if the gate is
free to open completely stopping on the travel limit
mechanical stops and if leaf movement is good and
friction- free.
10)
Definitively weld the front attachment on the leaf.
To do this, temporarily release the operator from the front
attachment to prevent welding waste from damaging it
(Fig.10).
A)
We advise you to grease all the securing pins of
the attachments.
B)
If welding is impossible, the plates of the front and
rear attachments are designed to be secured with
screws if necessary.
Fig. 9
Fig. 6
Fig. 7
Fig. 10
Fig. 8
Содержание 402
Страница 1: ...Leading the way Installation Manual 402 Leading the way Leading the way Swing Gate System ...
Страница 12: ......