F5 i5000 Series, Настройка

Страница: 15 / 30

Figure 13: The RJ45F to RJ45M rolled serial (pass-through) adapter (CBL-0143-00)
3. Connect power to installed power supplies:
Note: Be sure to route the power cords away from the fan tray so that the cords do not impede access
to it.
• For AC-powered systems, connect an auto locking power cable to the power input panel on all
installed power supplies, and then connect the cable to the power source.
Note: Not all country-specific power cables include a locking feature.
Note: To remove the locking power cord, pull one or both of the power cord locking tabs away from
the power supply.
• For DC-powered systems, connect a DC cable to each power supply and then connect the cable to
your DC mains power source.
4. If you plan to set up device service clustering (DSC
®
) with hard-wired failover capacity, connect the
serial failover cable to the FAILOVER port on each unit.
For more information about configuring failover, see BIG-IP
®
Device Service Clustering: Administration
at
support.f5.com
.
You can now assign a management IP address to the system, and then license and provision the software.
Optionally, you should run the
QKView
utility. This utility collects configuration and diagnostic information
about your system into a single file that you can provide to F5 Technical Support to aid in troubleshooting.
For more information, see
support.f5.com/csp/article/K12878
.
Configure a management IP address using the LCD
You can use the touchscreen LCD to configure the management IP address. With the management IP address,
you can access the BIG-IP
®
Configuration utility to configure other aspects of the product, such as the
product license, VLANs, and trunks.
Note: When using the LCD to configure the unit, be sure to use the Commit option to save all settings.
15
Setting Up the i5000/i7000/i10000/i11000 Series Platform