F5 ARX-2000, Руководство по установке оборудования

Страница: 70 / 80

Appendix A
Removing and Replacing FRUs
A - 12
Replacing the Chassis
Some failures will require you to swap out the entire ARX-2000 chassis.
This involves stepping through the following procedure which includes
failing over and powering down the failed switch.
copy the running config to another box somewhere and they only need to
copy the global if it is a standalone install
1. Use the copy running-config command to copy the current running
configuration to another system. If the ARX-2000 is a standalone
installation, use the
copy global-config command to copy the global
configuration to another system.
2. Write down the switch’s system password, the IP address and
subnet mask for the out-of-band management port, the UUID, the IP
address for the private internal subnet, and the system master-key.
These parameters were all set when the switch was installed. You
can use the
show master-key command to get an encrypted copy of
the master key.
3. Power down the failed switch by pressing the power button located
on the front panel. See Figure 2.3 .
4. Turn off and unplug all peripheral devices connected to the
ARX-2000.
5. Label each network cable with the name of the port to which it was
connected.
6. Remove all cables, including all power cables.
7. Remove any screws that hold the switch in the rack.
8. Pull the switch out of the rack.
9. Remove the ear assemblies.
10. Remove the front bezel.
11. Install the replacement switch in the rack. If necessary, reattach the
ear assemblies.
12. Slide the switch back into the rack.
13. Reattach the front bezel.
14. Attach all cables, including the power cables.
15. Connect to the console port (on the back of the switch).
16. Power the switch on by pressing the power button located on the
front panel. See Figure 2.3 .
17. Complete the switch replacement option of the Switch
Configuration Wizard. When prompted, enter the UUID and private
subnet information collected in step 1. For an example, see
Preparing for Switch Replacement, on page 3-6 .