EZSTEP EVO-PROSTEP, Руководство пользователя

Страница: 37 / 61

→
DO NOT use in wells filled with water
→
NOT by impact or any similar actions that
cause damage
→
DO NOT stretch it too far aside at work. Tip:
The abdominal center of the user must always
be inside the circuit during work. Both feet
belong to the same ladder glazing bar!
→
Do NOT descend from the landing ladder from
a great height - if there is no other alternative,
secure the ladder beforehand, for example by
tying it up.
→
DO NOT use a ladder step to climb to a higher
level. Generally, use the ladder for short-term,
light work
→
DO NOT use the ladder outside in bad weather
(for example, storm, heavy rain)
→
Do not let children play with the ladder
→
Do not work in open Windows and doors,
where feasible (emergency exits are of course
an exception)
→
Does not let the ladder work on which, if the
side load, such as drilling, is too large
→
DO NOT work too long on the ladder. Take
breaks!
The 6 ladder commandments
→
Getting on and off I: Turn the ladder over!
→
Getting on and off II:
Always hold on well to
the ladder.
→
Secure: In case of working on the ladder,
always hold with one hand. Not possible? Then
reach to other security glazing bars!
→
Footwear:
Wear suitable, firm shoes when
using the ladder
→
Single ladder and next level: If the ladder is
to reach a higher level, the ladder must extend
at least one meter above the corresponding
descent point
→
Equipment: Use only light equipment that is
easy to handle.
The care and maintenance
First check, then use:
→
Telescopic beams must not be bent, twisted,
dented, cracked or corroded and must be
undamaged, especially at the connection points
→
Hardware (rivets, screws, etc.) must be firmly
and fully attached.
→
All glazing bars must be present and functional.
No wear, no corrosion.
→
Rubber feet and protective caps must be
complete and intact, no benefits, no corrosion
→
The ladder must be completely clean
→
The locking devices are intact (no damage, no
corrosion)
IMPORTANT: only use the ladder if everything
is alright and all functional properties are met.
Precision needs care:
Always keep clean the ladder, especially the
telescope tubes, so that it lasts long and
not lose its stability. Never use them
without the rubber pads and protective
caps (both are wearing parts, you can
buy them from specialist dealers). The
latter ensure that no foreign bodies enter the
telescopic poles.
Repair only by a specialist:
Because this is qualified and knows how the
telescopic ladder must be repaired, if necessary.
If so, do not use it until it has been expertly
repaired. Only use original parts for material
exchange!
IMPORTANT: The information label on the
ladder must be legible! If that is no longer
the case, order a new sticker immediately.
Contact your dealer or use the order
address on the back of the instructions for
use.
Once again briefly, succinctly and
summarized on what we, as manufacturer
particularly, want to clarify:
a) The ladder must be set up in the correct
installation position, for example, the correct
angle for launching ladders (inclination angle
36
UK