EZ STEP 126000, Руководство пользователя

Страница: 32 / 110

Operation Manual Telescopic Ladder
About the Telescopic Ladder
Your telescopic ladder has two practical
basic functions, because you make big
things out of small things: you can expand
them either from their compact format to
their full length or to an intermediate length.
How to use, maintain and repair it
You would like to enjoy your ladder for a long
time. No problem: Just follow these instructions!
What is most important to your safety
Before you start off, the stabilising bar must
be installed, it is enclosed due to the ladder
length. Use the list below to check whether
all assembly parts are available for this
purpose.Before you use your ladder, it must
be properly locked after extending. Please
always note: do not climb onto the ladder
until all the rung segments are blocked!
Mounting the stabiliser bar:
Slide the end caps A onto the stabiliser bar D
and secure the caps from below using the
enclosed screws B. Now, assemble the
connection adapters C on the bar D. Be sure
to mount both adapters, so that they are
screwed together using the attached
screws B and that both are mounted on
the bar at the same angle. Slide the
pre-assembled bar into the ladder frame D.
Now the most important thing is to place
the ladder with the front side facing yourself
(step extensions extend at the rear). The
longer side of the already installed adapter
C must now point towards you and into the
tubes. Then screw it firmly using the supplied
screws B. Check: if the stabiliser bar is
extended evenly on the floor, the ladder will
point obliquely to the wall and does not
face you.
1. How to extend the telescopes to their
full length
Good to know: After extending the ladder, it locks
automatically. Note that each segment has its
own lock mechanism.
How to extend the ladder:
A) Place the ladder upright on a dry, horizontal
surface. Extend the ladder and proceed as
follows:
-> Hold the bottom ladder rung down with one
foot
B) Now extend the ladder and start from the
top:For this purpose, grasp the top rung
and pull it upwards until the rung segment
completely engages. Then pull out the
individual rung segments one after the
other until the ladder is fully extended.
C) The segments¬ automatically engage one
after the other. Important: The locking bars must
now drop at an angle of 60 degrees and the
locking buttons on the last but one rung will
display the closed lock symbol.
D) You now need to check: Are all rung segments
locked? Are all locking latches fully extended?
Important: You will find the locking buttons at the
second bottom rung. When the rung segments
are locked, these buttons point to the closed
lock symbol. If this does not happen immediately,
jog a little on the ladder until all segments snap
into the respective locking position. When
everything is fixed, we can start.
E) Now we need to perform the assembly: To
ensure that the ladder is secure, it should be
placed at an angle of 75 degrees to the ground.
2. How to extend the telescopic ladder to an
intermediate length
A) Place the ladder upright on a dry,
horizontal surface. Extend the ladder and
proceed as follows:
-> Hold the bottom ladder rung down with one
foot
31