EYENIMAL DELUXE GROUND+ FENCE, Руководство пользователя, Страница: 10 / 40

- 6 -
1000 ft installation, selector position « small ground »
LCD screen
Zones settings
(levels)
Approximate width of the zones
on each side of the wire
MINIMUM warning = 1
MAXIMUM warning = 40
MINIMUM warning ~ 0 ft
MAXIMUM warning ~ 9 ft
MINIMUM
static correction
= 0 No
static correction
area.
Only beep sounds are emitted.
MINIMUM warning = 21
MAXIMUM warning = 40
MINIMUM warning ~ 4 ft
MAXIMUM warning ~ 9 ft
MAXIMUM
static correction
= 8 MAXIMUM
static correction
~ 4 ft
500 ft installation, selector position « small ground »
LCD screen
Zones settings
(levels)
Approximate width of the zones
on each side of the wire
MINIMUM warning = 1
MAXIMUM warning = 40
MINIMUM warning ~ 1.6 ft
MAXIMUM warning ~ 18 ft
MINIMUM
static correction
= 0 No
static correction
area.
Only beep sounds are emitted.
MINIMUM warning = 21
MAXIMUM warning = 40
MINIMUM warning ~ 6 ft
MAXIMUM warning ~ 18 ft
MAXIMUM
static correction
= 8 MAXIMUM
static correction
~ 6 ft
IMPORTANT: the widths indicated are approximate and vary depending on the configuration of each installation.
●
Testing the pet fencing system (boundary range)
Before releasing your dog into his play area, you need to physically evaluate the extent of the authorized zone. Make sure your dog has
enough space to move freely within the defined limits.
The wider the zones, the lower the escape risks. Therefore, you have to find a good compromise between zone width and freedom space.
In order to test the installation, proceed as follows:

Before doing so, make sure the receiver collar is turned Off (battery removed from its housing).

Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and retightening them so as to pinch the test
lamp wires).

Turn On the transmitter and the receiver collar.

Put the selector in position “small ground” or “large ground” depending on your installation.

Set the warning and static correction zones on the levels that seem appropriate.

Stand at the center of the authorized area holding the collar by the strap at the same height and orientation as if on your dog’s neck.
Then walk towards the edge of your property where the antenna wire is laid. At a certain distance from the wire, the collar should emit
beep sounds. Then, when you carry on, the neon test lamp should light indicating static corrections are emitted. If you think the zones
are insufficient or too important, go back to the transmitter to modify the settings. Use the
and buttons to modify the width of
the warning zone. Use the button to modify the width of the static correction zone. Change the selector position. Check the new
settings on your property. Test the settings in a number of different areas of the installation to ensure that the functioning is constant.

When the zone setting is complete, walk all around the authorized area holding the collar by the strap at the same height and
orientation as if on your dog’s neck in order to check that there is no loss of signal.

Before disconnecting the neon test lamp, make sure the receiver collar is turned Off (battery removed from its housing).