Vtracker/WitnessPro-2.0
www.eye3data.com
21
DATE FORMAT:
(US or International):
Press
【
ENTER
】
to select format desired: MM/DD/YYYY,
DD/MM/YYYY, or YYYY-MM-DD.
TIME FORMAT:
Press
【
ENTER
】
to select the time format desired: 12H or 24H.
TIME SYNC SOURCE:
The system will allow the time to be synchronized via “GPS” or “NTP”.
GPS option
If selecting the “GPS” option, the device must have a GPS connection
and a good GPS signal.
NTP option
If selecting the “NTP” (Network Time Protocol) option, the device
must have a network access connection and an assigned NTP IP
location. This process runs at 6:30am local time when the system has
a network connection.
TIME ZONE:
Please choose the correct time zone for the vehicle location. This is
the time zone in which the vehicle is located.
SYNC TIME:
This is the time when the unit will sync with the server every day. This
method depends on the setting in the TIME SYNC SOURCE option.
NTP SERVER IP:
In order to use the NTP feature, please enter the IP address to the
NTP server. [Example: "192.43.244.18", "129.6.15.28",
"211.22.55.116", "194.88.2.60"]
DST:
Daylight Savings Time. The following option is available, only when
it is set to ON.
DST MODE:
There are two modes: Auto / Manual. Auto: According to the
International DST, i.e.: valid only between 2AM on Second Sun in
March and 2AM on First Sun in NOV.
Select
【
SAVE
】
to save the settings.
2.2 General
ON/OFF TYPE
: There are three options:
IGNITION, TIMER and IGNITION OR TIMER
A)
IGNITION
:
This function allows for a shut down delay. For example: If you set the shut down delay
function time at five minutes, then every time the ignition is turned off the WitnessPro/VTracker will shut
down after five minutes.
When setting the DST, the former date must be earlier than the later date; otherwise, if the two setting dates are the
same, the DST will be invalid.
