Installation & User Manual, Radio Remote RC11E
Page 3
Technical specifications
• You must always install at least one original Exturn panel.
•
With the boat on land, only run the thruster for a fraction of a second, as without resistance it
will accelerate very fast to a damaging rpm.
•
This manual is intended to support educated / experienced staff and is therefore not sufficient
in all details for the correct installation.
•
When installed in boats approved or classified according to international or special national
rules, the installer is responsible for following the demands in accordance with these regula
-
tions / classification rules. The instructions in this guide can not be guaranteed to comply with
all different regulations / classification rules.
•
The transmitter and the receiver have the same factory preset code so no programming is nec
-
essary. When additional transmitters are to be used, the receiver must be programmed again
for all transmitters (please see programming section on page 7).
•
If a Exturn automatic main switch is fitted, the “OFF” button on your transmitter will shut off the
main switch providing no other control panels are “ON”.
Transmitter
Receiver
Model
RCT-11XE
RCR-1XE
Power feed
1 x 3V battery (type: CR2032)
From thruster
Frequency (MHz)
433,2
433,2
Operation temp.
-10°C / +55°C
-15°C / +55°C
HxWxD (mm)
95x48x25
89x68x33
Weight (g)
60
135
Voltage:
8-30V
Load, max
4A
Operating range: 15m under normal operating conditions
Important precautions
