Installation & User Manual, Radio Remote RC11E
Page 2
Model range................................................................................................................................ 2
Technical specifications
.............................................................................................................. 3
Important precautions
................................................................................................................. 4
Receiver installation
................................................................................................................... 6
“Visual” wiring diagram
................................................................................................................ 6
Programming additional transmitters
........................................................................................... 7
Replacing the batteries
............................................................................................................... 8
User precautions
........................................................................................................................ 9
How to use Exturn thrusters
...................................................................................................... 10
Service Partners
...................................................................................................................... 12
Model range
Contents
The radio remote control can control a single bow thruster or a bow and stern thruster combined.
The receiver can receive the signals of up to four transmitters.
Remote control kit (RC-11XE) consists of:
- Receiver: Part no. RCR-1XE
- Transmitter (incl. battery): Part no. RCT-11XE
- Holding bracket for transmitter unit: Part no. RC-HOLDER
Additional transmitters can be ordered separatly: Part no. RCT-11XE
Antenna is available as spare part no. RC-ANT
The transmitter and the receiver have the same factory preset code so no programming is neces
-
sary. The battery is already inserted in the transmitter.
When additional transmitters are to be used, the receiver must be programmed again for all trans
-
mitters (please see programming section on page 7).
We
Sleipner-Marinno Gmbh
declare that
this device complies with health and safety
requirements according to the Directives
EN301 489-3 V1.4.1:2002
EN301 489-1 V1.4.1:2008
IEC 60533:1999
EN300 220-1 V2.3.1:2010
EN300 220-2 V2.3.1:2010
