extronics iTAG X30, Руководство по эксплуатации

Страница: 20 / 29

20
4.6
Over the Air (OTA) update
When new firmware becomes available the
iTAG X30’s firmware can be OTA updated.
The tag has a button on the rear that needs to be pressed down, Figure 16.
Figure 16.
Updating is performed as follows:
1. Place
a pen’s nib or similar sized item inside the OTA button and gently and
continuously press down.
2. The iTAG X30 will begin beeping (once per second) and the top LED will flash
green.
3. Once a faster beep is heard the button can be released
– after approximately ten
seconds.
4. The top LED will flash red and front LEDs flash as the iTAG X30 starts to download
the new firmware. This can take over 15 seconds depending on network speed.
5. Once the download has completed the top LED will blink green and iTAG X30 will
reset.
6. Upon successful install all three front LEDs will flash 4 times.
7. Finally, the top green LED will then flash as usual.
Should the install fail the top LED will flash red quickly. The following checks can be
made:
1. Check that the iTAG X30 Wi-Fi settings are correct. If so, the button press process
described above should be repeated.
2. Check network connectivity.
3. Check ELS Deployment Guide, Section 6.2.
4. If multiple fails occur then please contact Extronics Technical Support.
OTA