YCS 100 • Installation and Operation
Installation and Operation
YCS 100 • Installation and Operation
2-2
2-3
3
.
Install blank panel(s) or other unit(s) on the rack shelf as
desired.
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Figure 2-1 — Mounting a YCS 100 (with other units)
on a VersaTools rack shelf
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
1/4 Rack Width Front False
Faceplate
1/2 Rack Width Front False
Faceplate
Figure 2-2 — Mounting a YCS 100 on a standard
rack shelf
Installation Overview
To install and set up the YCS 100, follow these steps:
1
Mount the YCS 100 on a rack shelf, furniture, or projector
bracket if desired.
2
Connect your input and output devices to the YCS 100’s
rear panel connectors.
3
Wire the provided 2-pin captive screw connector to the
external power supply. (See
Wiring the Power Connector
,
later in this chapter.)
4
Apply power to the YCS 100 and to the input and output
devices.
Mounting the YCS 100
The YCS 100 can be set on a table; mounted on a rack shelf;
mounted under a desk, podium, or table; or attached to a
projector with one of the Extron projector mounting kits.
Tabletop use
Four self-adhesive rubber feet are included with the YCS 100.
For tabletop use, attach one foot at each corner on the bottom of
the unit, and place the YCS in the desired location.
Rack mounting
For optional rack mounting, do not install the rubber feet.
Mount the transcoder on one of the following rack shelves:
•
1U 3.5" Deep VersaTools
®
rack shelf
Standard (RSF 123, part #60-190-20) or Basic (RSB 123, part
#60-604-20)
•
1U 9.5" Deep rack shelf
Universal (RSU 129, part #60-190-01) or Basic (RSB 129,
part #60-604-01)
•
1U 6" Deep Rack Shelf
Universal (RSU 126, part #60-190-10) or Basic (RSB 126,
part #60-604-10)
Mounting on a rack shelf
1
.
If feet were previously attached to the bottom of the YCS,
remove them.
2
.
Mount the YCS 100 on the rack shelf, using two
4-40 x 3/16" screws in opposite (diagonal) corners to
secure the unit to the shelf (see fi gures 2-1 and 2-2, on the
next page, or fi gure 2-3 on page 2-4).
