YCS 100 • Installation and Operation
Installation and Operation, cont’d
2-6
YCS 100 • Installation and Operation
2-7
Projector mounting
To projector-mount the YCS 100, use one of the three optional
mounting kits described in the following sections.
Using the PMK 100 Mini Projector Mount Kit
The PMK 100 is a projector mounting kit (part # 70-217-01)
designed for use with Extron 1U high, quarter-rack width
products like the VersaTools products. It allows them to be
mounted near or on a projector support.
Follow these steps to projector-mount the YCS 100 using the
PMK 100 kit:
1
.
If rubber feet were previously attached to the bottom of the
unit, remove them.
2
.
Remove the two screws from one side of the YCS. Retain
the screws for possible later reassembly.
3
.
Attach the projector mounting bracket to the side of the
unit, using the provided machine screws.
Ceiling
Projector
Projector
Mounting
Bracket
Mounting
Bolt
Figure 2-7 — Projector-mounting the YCS 100 using
the PMK 100 Projector Mount kit
4
.
Secure the unit to a projector mount or other surface by
inserting the mounting bolt through the bracket’s slotted
hole.
Furniture mounting
To furniture-mount the YCS 100, use the optional MBU 123
VersaTools under-desk mounting kit (part #70-212-01), as
follows.
1
.
If rubber feet were previously attached to the bottom of the
unit, remove them.
2
.
Remove the two screws from one side of the YCS. Retain
the screws for possible later reassembly.
3
.
Attach one bracket to the side of the unit, using the
provided machine screws (see fi gure 2-6, below).
Figure 2-6 — Preparing the YCS 100 for under-desk
mounting
4
. Repeat
steps
2
and
3
on the other side of the YCS.
5
.
Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket’s screw holes.
6
.
Drill 3/32" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep
in the mounting surface at the marked screw locations.
7
.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than ¼" of the screw head protrudes.
8
.
Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
9
.
Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
