Extron electronics XTP T USW 103 4K, Руководство пользователя

Страница: 26 / 52

XTP T USW 103 4K Switcher • Operation 18
EDID
To manage EDID on the XTP T USW 103 4K, use the XTP System Configuration Software
(see
EDID Minder
on page 40). The XTP T USW 103 4K can record and save EDID in a
user memory location, select a pre-defined EDID, or use EDID from a display connected to a
receiver. EDID stored in the user memory location can come from the display connected to
a receiver or a custom EDID imported through the XTP System Configuration Software.
NOTE: In matrix applications, EDID on the switcher is assigned by the matrix switcher
using the XTP System Configuration Software.
Reset Mode
Use the recessed
Reset
button on the rear panel of the switcher (see figure 12,
A
) to
return the device to default settings or to restore factory-shipped firmware.
SIG LINK
LAN XTP OUT
POWER
XTP T USW 103 4K
12V
--A MAX
AUDIO
1 2 3
RGB
HDMI DISPLAYPORT HDMI OUT
Rx G Tx
RS-232 IR
Rx Tx
G
CONTACT
G
RS-232
Tx Rx 1 2 3
TALLY OUT
+V 1 2 3
R
INPUTS
A
Figure 12. Rear Panel Reset Button
Rest Mode Summary
Mode Activation Result Purpose and Notes
Factory
Firmware
Reset
(mode 1)
Press and hold the recessed
Reset
button while applying
power to the device.
NOTE: After this reset,
update the device with the
latest firmware version. Do
not operate the device with
the firmware version that
results from this reset.
The device reverts to the factory
default firmware for a single power
cycle.
NOTE: If this reset was
performed by mistake or
is no longer desired, cycle
power to the device again to
restore the firmware version
running prior to the reset.
Use this reset to return the
firmware back to the factory
firmware temporarily if an
incompatibility issue arises
with the current firmware.