Locking Screw
Locking Plate
Figure 25.
Locking Plate and Locking Screw
2.
Remove the screw holding the locking plate at the bottom of the base. This releases the
weight, which can be removed from the top of the base, leaving the mounting hole that will
fit over the conduit of the SMA-1.
3.
Attach the conduit, insulation disk, and swivel disk and configure the set screws to allow for
the degree of swivel that is required (see the
SMA-1 Swivel Mount Adapter Kit User Guide
,
available at
www.extron.com
).
4.
Place the mounting hole in the base over the conduit of the SMA-1.
5.
Secure the unit with the backing plate and locking nut as described in the
SMA-1 Swivel
Mount Adapter Kit User Guide
.
VESA Mounting
Removing the base
1.
Remove the back cover and base cover using the Extron removal tool, as described in
SMA-1 swivel mount adapter on the previous page.
2.
If necessary, cut the zip tie holding the twisted pair cables to the touchpanel base.
3.
If necessary, remove the cables from the cable runway in the base.
VESA Mounting
Holes (4)
Spanner Drive
Security Screws (4)
Hinges
Cable Runway
Figure 26.
TLP Pro 720T Rear View
4.
Remove the four spanner drive security screws holding the hinges to the touchpanel.
NOTE:
The spanner drive screws holding the hinges require a #6 spanner bit or #6
spanner head screwdriver (not provided).
5.
Lift the TLP away from the base.
TLP Pro 720 Series and TLP Pro 1020 Series • Mounting
28