A
Power connector
(see
figure 5
, on the previous page)— power supplies must be
purchased separately.
TLP Pro 720T and TLP Pro 1020T — Connect a 12 VDC, 1.0 A power supply with DC plug
to the rear panel power receptacle. Extron recommends using the PS 1210 P power supply
(part number 70-778-01).
TLP Pro 720M and TLP Pro 1020M — Connect a 12 VDC, 1.0 A power supply with a
captive screw connector to the rear panel receptacle. Ensure the connections have the
correct polarity as shown below. Extron recommends using the PS 1210 C power supply
(part number 70-775-01).
Power Receptacle
Captive Screw Connector
SECTION A–A
Ridges
Smooth
Power Supply
Output Cord
A
A
3/16"
(5 mm) Max.
Ground
all devices.
External
Power Supply
(12 VDC, 1 A max.,
Extron PS 1210C)
– Return
+12 VDC input
Ridged
Smooth
1A MA
X
100-240V 50-60H
z
Figure 6.
Power Supply Connection
WARNING:
The two power cord wires must be kept separate while the power
supply is plugged in. Remove power before wiring.
AVERTISSEMENT :
Les deux cordons d’alimentation doivent être tenus à l’écart
l’un de l’autre quand l’alimentation est branchée. Couper l’alimentation avant de
faire l’installation électrique.
CAUTION:
Risk of Explosion
if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
ATTENTION
:
Risque d’explosion.
Ne pas remplacer la pile par le mauvais type de
pile. Débarrassez-vous des piles utilisées selon le mode d’emploi.
ATTENTION:
•
Do not power on the touchpanels or control processors until you have read
the Attention notice on
page 10
(12 VDC power supply) or on
page 12
(power
injector).
•
Ne branchez pas les écrans tactiles ou les contrôleurs avant d’avoir lu les mises
en garde
page 10
(source d’alimentation 12 VCC) ou
page 12
(injecteur PoE).
NOTES:
•
These touchpanels ship without a power supply. Either the 12 VDC power supply
or the power injector must be purchased separately.
•
If a 12 VDC and a PoE power supply are both connected to the touchpanel, the
power injector takes precedence. If a PoE power loss is detected, the touchpanel
switches seamlessly to the 12 VDC supply without needing a system reboot.
TLP Pro 720 Series and TLP Pro 1020 Series • Panel Features
9