Mounting the TLP 700MV
A variety of mounting kits are available for the TLP 700MV (see
for a complete list). These kits must be purchased
separately. The touchpanel must be mounted by following the instructions provided with the mounting kit.
To mount the TLP 700MV in the wall, follow these instructions and see the figure below. The steps can be easily adapted if the unit is
mounted in furniture (such as a podium or table).
1.
Remove the TLP 700MV from its packaging and determine the best location for installation.
2.
Remove the bezel from the TLP 700MV.
3.
Download the TLP 305MV template from www.extron.com. Print at 100% (do not scale).
4.
Use the template to mark the wall or furniture and cut a hole.
5.
Ensure all the locking arms are flush with the top and bottom surfaces of the unit.
6.
Insert the trim ring and the TLP 700MV to test the hole is the correct size. If necessary, use a rasp or a coarse file to enlarge the
hole.
7.
Run the network cable, two BNC video cables, and power supply cables inside the wall of the hole, leaving enough slack in the
cables to connect them to the back of the TLP 700MV. Use the provided power supply for correct operation.
ATTENTION:
•
Do not connect any external power supplies until you have read the Attention notifications in the Power Supply section
of the
TLP 700MV and TLP 700TV User Guide
.
•
Ne branchez pas de sources d’alimentation externes avant d’avoir lu les mises en garde dans la section
« Power Supply » du
TLP 700MV and TLP 700TV User Guide
.
8.
Secure the TR 700M trim ring (recommended by Extron) to the wall using four screws (see the figure below).
9.
Plug the cables into the rear panel connectors.
10.
Push excess cables into the wall cavity and fit the TLP 700MV into the hole.
11.
Use a Phillips head screwdriver to tighten the screws. As the screws tighten, the locking arms rotate into position behind the wall
and hold the unit in place.
ATTENTION:
•
Do not overtighten the screws as this can damage the catches or the wall.
•
Ne serrez pas trop les vis au risque d’endommager les attaches ou le mur.
Bezel snaps to unit
(4 places on each side).
Tighten screws to
rotate locking arms.
Trim Ring (recommended)
secured to the wall
with screws (4).
Figure 2.
Mounting the TLP 700MV in the Wall
12.
Do not replace the bezel at this time because you will need access to recessed
Menu
and
Reset
buttons to configure the unit.
Figure 2
2
TLP 700MV • Setup Guide (Continued)
