Extron electronics RGB 130xi, Руководство пользователя, Страница: 21 / 38

RGB 130
xi xi xi xi xi
, 134
xi xi xi xi xi
, 150
xi xi xi xi xi
Controls and Installation 2-14
Setting the DIP switches
DIP switches can be found on the front panel of the RGB
150
xi and on the rear panels of the RGB 150 xi , 130 xi , and
134 xi . The switches may be either the rocking type or the
sliding type.
To set the rocking-type DIP switches, use a
small screwdriver to depress the
appropriate end of each switch.
To set the sliding-type DIP switches. use a
small screwdriver to slide the switch to
the on/closed or off/open position.
The RGB 150 xi has two pin termination DIP
switches to provide proper ID bit termination for a
laptop computer that is not attached to a local
monitor.
ID PIN 4 & ID PIN 11
ON — Set both pins to On if you are using the
RGB 150 xi interface with a laptop
computer that is not attached to a local
monitor.
OFF — Set both pins to Off if you are attaching a
local monitor to the interface.
3 4 1 2
3 4 1 2
The RGB 130
xi
, 134
xi
, and 150
xi
have four DIP
switches on the rear panel to control: sync on
green output, digital display sync processing,
serration pulse, and 75-ohm input termination
(except for the RGB 150
xi which has a spare).
SOG (sync on green output)
ON — If this switch is set to On, the interface
outputs a composite sync signal on top
of the green video signal via the G
output connector (RGsB).
OFF — If the SOG feature is set to Off, output is
RGBS or RGBHV, depending on how the
interface and projector are cabled.
DDSP™ (digital display sync processing)
ON — If this switch is set to On, the interface
does not perform sync processing. This
may be necessary for digital display
ID PIN 4 ID PIN 11
SOG DDSP SERR 75 Ohm