Extron electronics RGB 130xi, Руководство пользователя, Страница: 14 / 38

RGB 130
xi xi xi xi xi
, 134
xi xi xi xi xi
, 150
xi xi xi xi xi
Controls and Installation
Installation
Easy setup procedure
Except where noted, the installation procedures for the RGB
130
xi , 134 xi , and 150 xi are the same. See “Cabling” in this
chapter for more information.
1
If desired, mount the interface to a desk or other
suitable surface using Extron’s optional mounting
kit. See “Mounting the interface” in the next section.
2
Turn off power to the computer or workstation and
its monitor. Turn off power to the projector or
display device. Disconnect the power cord from the
interface.
3
Connect the computer to the Analog/ECL* input
connector on the front of the interface. If an MBC
interface output cable is being used with the RGB
134
xi , connect the MBC cable to the Analog/ECL
connector and connect the MBC power cable to the
MBC power jack. Refer to the diagram in the
“Cabling” section of this chapter.
4
For the RGB 150 xi , if a local computer monitor is
being used, connect the monitor to the Buffered Local
Monitor Output connector.
5
For audio connections, please refer to the following
“Cabling” and “Connecting audio output” sections.
6
Connect the projector or other output display device
to the interface’s BNC output connectors, as
described in the “Cabling” section.
7
Set the interface’s DIP switches. Refer to the section
“Setting the DIP switches” at the end of this chapter.
8
Power on the computer, monitor, projector/display
device, and the interface. The image should now
display on screen. If it does not, double check steps 2
through 7 and make adjustments as needed. To
adjust horizontal and vertical sync polarity and to set
vertical sync pulse width, please refer to the “Setting
internal jumpers” section at the end of this chapter.
* RGB 150 xi is analog only
2-7
Controls and Installation, cont’d