Extron electronics PowerCage FOX Rx HDMI, Руководство пользователя

Страница: 38 / 45

PowerCage FOX HDMI • Remote Control 30
HDCP area
NOTES:
• The HDCP Authorized controls are available only if your
computer is connected to the transmitter.
• The HDCP Notification controls are available only if your
computer is connected to the receiver.
•
Both sets of radio buttons cannot be available for selection
at the same time.
HDCP Authorized radio buttons
— The HDCP Authorized setting allows a user to turn
off HDCP communication on a discrete input. This setting is useful for devices such as Mac
computers, iPhones, iPads, and some Windows 7 sources that always encrypt their output
if the downstream sink is capable of HDCP. By not allowing HDCP signals on an input, most
content from these sources can be passed as a non-encrypted signal to analog and digital
video outputs. In a video system that has requirements to not transmit HDCP encrypted
data (such as non-HDMI FOX Extenders), HDCP support should be turned off at the input to
keep the non-HDMI output of the FOX Extender unencrypted.
HDCP Notification radio buttons — The HDCP notification function in the receiver
enables a connected display to show a green or black screen if the transmitted HDMI video
is HDCP encrypted and the display is not HDCP capable.
Assigned EDID area
NOTE:
The Assigned EDID area control is available only if
your computer is connected to the transmitter and EDID
Minder hex switch, on the side panel of the transmitter, is in
position 1. If the hex switch is not in position 1, the Assigned
EDID area advises you “
To change EDID , set rotary
switch from # n to # 1 .“
The Assigned EDID area provides a drop-down box that let you
manually set the EDID resolution and refresh rate and reports the
position of the EDID Minder hex switch.
Plus Mode Transmission area
NOTE:
The Plus Mode Transmission radio buttons are available only
if your computer is connected to the transmitter.
The Plus Mode Transmission radio buttons allow you to enable and disable Plus mode.
• Enabled forces the transmitter to emulate a PowerCage FOX DVI Plus or
FOXBOX DVI Plus transmitter for compatibility with one of four receivers: a
PowerCage HDMI Rx, a PowerCage FOX DVI Plus Rx, a FOXBOX HDMI Rx, or a
FOXBOX DVI Plus Rx.
• Disabled allows the output of the transmitter to be received by any PowerCage FOX,
FOXBOX, and FOX 500 VGA and DVI unit, including the Plus and non-Plus units.