Extron electronics PowerCage FOX Rx HDMI, Руководство пользователя

Страница: 27 / 45

PowerCage FOX HDMI • Remote Control 19
Using the Command and Response Tables
The command and response tables begin on page 20. Either uppercase or lower case
letters are acceptable in the command field except where indicated for the audio level (gain
and attenuation) commands. Symbols are used throughout the table to represent variables
in the command and response fields. Command and response examples are shown
throughout the table. The ASCII to HEX conversion table below is for use with the command
and response table.
ASCII to Hex Conversion Table
•
Space
Symbol definitions for transmitter SIS commands
]
= Carriage return/line feed
}
= Carriage return (no line feed)
| = Pipe (can be used interchangeably with the
}
character)
• = space
E
= Escape key
W = Can be used interchangeably with the
E
character
X!
= EDID hex switch position 00 = N/A 08 = 1360 x 768
01 = RS-232 control 09 = 1366 x 768
02 = 800 x 600 10 = 1400 x 1050
03 = 1024 x 768 11 = 1440 x 900
04 = 720p* 12 = 1600 x 1200
05 = 1280 x 768 13 = 1680 x 1050
06 = 1280 x 800 14 = 1080p*
07 = 1280 x 1024 15 = 1920 x 1200
* 720p and 1080p also include a block for embedded audio; all other
positions are video only
X@
= Refresh rate 1 = 50 Hz 2 = 60 Hz
X#
= EDID See the
table
on page 20.
X$
= Native resolution Resolution and rate in an easily-viewed format, such as “ 800x600@60Hz “.
X%
= EDID record 128 or 256 bytes
X^
= Audio gain adjustment range 00 to 10
X&
= Audio level adjustment range –18 to +10 (in 1.0 dB steps)
X*
= Audio attenuation adjustment range 00 to 18
X(
= Mode switch position and enable or disable status 0 = off (down) or disable 1 = on (up) or enable
X1)
= Link and input status 0 = link or input not detected 1 = link or input detected
X1!
= Internal temperature nnn F• nn C
X1@
= Transmission mode SM = singlemode MM = multimode
X1#
= Firmware version v . vv
X1$
= Sync frequency xxx . xx (frequency in kHz [H] or Hz [V])