13
MTP 15HD A Series • Installation and Operation
Installation and Operation, cont'd
Receiver
Figure 8 shows an MTP RL 15HD A receiver, which has all of the
connectors and other features that are on either receiver in the
MTP 15HD A series.
INPUT
BUFFERED
OUTPUT
OUTPUT
POWER
12V
.5A MAX
MTP RL 15HD A
ON
1 2 3 4 5 6
H SYNC +
V SYNC +
C SYNC
SOG
VIDEO
END UNIT
1
MONO AUDIO
2
MTP RL 15HD A Receiver
NOTE
A “C7” label is affixed to
receivers designed for
DTP 26 or CAT 7 cable.
10
1
6
7
9
8
Figure 8 — Receiver rear panel features
Power connection
a
Power connector — Plug the included external 12 VDC power
supply into this 2-pole captive screw connector. See “
Power
supply wiring
” on page 16 to wire the connector.
Twisted pair connections
f
Input connector — Connect one end of the TP cable from the
transmitter or from the Buffered Output connector of an RL
receiver to this RJ-45 female connector. See “
TP cable
termination
” on page 17 to wire the RJ-45 connectors.
g
Buffered Output connector (RL receivers only) — Connect one
end of a TP cable to this RJ-45 female connector.
Connect the free end of the same TP cable from the receiver to
the Input RJ-45 female connector on another receiver.
See “
TP cable termination
” on page 17 to wire the RJ-45
connectors.
N
The buffered output on the RL receiver does not provide
pre-peaking control. The total recommended distance
for an entire daisy chain is the same as for a single
transmitter and receiver. The Pre-Peak switch has the
same effect on the recommended transmission distance
for a daisy chain as for a single transmitter and receiver.
N
Up to eight receivers can be connected in series using
Buffered Output connectors, provided that the total
distance from the TP output of the transmitter to the last
receiver in the chain does not exceed the recommended
distance for the resolution being used.
