Extron electronics IP Link IPL EXP 200, Руководство пользователя, Страница: 38 / 52

IPL EXP I/O Series • Hardware Features and Installation 30
IPL EXP I/O Series Expansion Interface Reset Mode Summary
Mode
Use This
Mode to... Activation Result
Reset All IP Settings
Reset IP
settings and
port maps
to factory
defaults
without
affecting user-
loaded files
To reset all IP settings:
1. Press and hold the Reset button until the Reset or Power
LED blinks once at 3 seconds and twice at 6 seconds.
2. Release and press the Reset button momentarily (for
<1 second) within 1 second*. The LED blinks 3 times in quick
succession upon successful reset.
* Nothing happens if the momentary press does not occur
within 1 second.
Reset All IP Settings mode:
•
Turns DHCP off.
•
Sets the IP address back to factory default:
•
LAN port: 192.168.254.250
•
Sets the subnet back to factory default
(255.255.255.0).
•
Sets the default gateway address to the
factory default (0.0.0.0).
•
Sets domain and host names to factory
default.
•
Sets port mapping back to factory default.
•
Turns events (user-created schedules,
macros) off.
•
Stops any running program.
•
Disables 802.1X authentication.
Reset to Factory Defaults
Start over with
configuration
and uploading
To reset the unit to all factory default settings:
1. Hold down the Reset button until the Reset or Power LED
blinks once at 3 seconds, twice at 6 seconds, and
three times at 9 seconds.
2. Release and press the Reset button momentarily (for
<1 second) within 1 second*. The Reset or Power LED blinks
4 times in quick succession upon successful reset.
* Nothing happens if the momentary press does not occur
within 1 second.
Reset to Factory Defaults mode performs
a complete reset to factory defaults
(except the firmware).
•
Does everything Reset All IP Settings
mode does.
•
Removes (clears) all user-loaded files
(except LinkLicense files) and configurations
from the control processor:
•
Clears driver-port associations (IR,
serial, Ethernet) and port configurations.
•
Removes button/touchpanel
configurations.
•
Removes user-loaded digital
certificates.
•
Removes schedules, settings, macros.
•
Clears messages in the event logs
table.
•
The unit continues to run the user-loaded
firmware.
NOTES:
• After performing a Reset All IP Settings or Reset to Factory Defaults reset, either set the IP address again (by
using Toolbelt) for use on your network, or turn DHCP on.
•
The factory configured passwords for this device have been set to the device serial number. Passwords are
case sensitive. Performing a Reset to Factory Defaults reset sets the password to
extron .
Use this text for the first 2 sentences once firmware
supports having DHCP on by default:
•
Turns DHCP on (for LAN ports).
•
Sets the IP addresses back to factory default (applies if
you turn DHCP off):
Use this text for the first 2 sentences once firmware supports
having DHCP on by default:
• After performing a Reset All IP Settings or Reset
to Factory Defaults reset, either leave DHCP on,
or turn it off and set the IP address again (by using
Toolbelt) for use on your network.