SIS Commands
This section provides information on:
z
z
Connecting a Control Computer
z
z
Simple Instruction Set (SIS) Control
z
z
Command and Response Table for SIS Commands
Connecting a Control Computer
Connect a control PC to the front panel config port using a USB cable (see "
Front Panel
Features
" on page 4). Remote communications are via SIS commands (see
page 19
). Use a
communication utility, such as Telnet, to send SIS commands and view the responses.
Simple Instruction Set (SIS) Control
Host-to-Interface Communications
SIS commands consist of one or more characters per field. No special characters are required
to begin or end a command sequence. When a command is valid, the interface executes the
command and sends a response to the host device. All responses from the interface to the
host end with a carriage return and a line feed (CR/LF =
]
), which signals the end of the
response character string. A string is one or more characters.
Error Responses
When the interface receives a valid SIS command, it executes the command and sends a
response to the host device. If the interface is unable to execute the command because the
command is invalid or it contains invalid parameters, it returns an error response to the host.
The error response codes and their descriptions are as follows:
E10 – Invalid command
E13 – Invalid parameter
Timeout
Pauses of 10 seconds or longer between command ASCII characters result in a timeout. The
command operation is aborted with no other indication.
Using the Command and Response Table
The "
Command and Response Table for SIS Commands
" is on page 19. Lowercase
letters are allowed in the command field only as indicated. Symbols are used throughout
the table to represent variables in the command/response fields. Command and response
examples are shown throughout the table. The ASCII to HEX conversion table, on the next
page, is for use with the command/response table.
HAE 100 HDMI Audio Extractor • SIS Commands
17
