Extron electronics FOXBOX Rx HDMI, Руководство пользователя

Страница: 13 / 51

FOXBOX Tx/Rx HDMI • Installation 5
Installation
This sections details the installation of the FOXBOX Tx/Rx HDMI, including:
•
Installation Overview
• Connections
• Operation
Installation Overview
Follow these steps to install and set up an Extron FOXBOX HDMI transmitter and receiver
system for operation:
1. Turn off all of the equipment. Ensure that the video sources and the output display are
all turned off and disconnected from the power source.
2. Mount the transmitter and one or more receiver (see Mounting the Unit on page 42).
3. Connect the cables and configure the receivers (see “ Connections ,” below).
4. Plug in the power supplies, then turn on the display devices and the input devices.
Connections
Transmitter Connections, Controls, and Indicators
FOXBOX Tx HDMI Rear Panel
Front Panel
12V
1.0A MAX
POWER FOXBOX Tx HDMI
AUDIO INPUT
RS-232
OVER FIBER ALARM
Tx Rx 1 2 HDMI INPUT
LINK
OPTICAL
Rx Tx
LINK
FOXBOX Tx HDMI
AUDIO HDCP HDMI
CONFIG
HDMI LOOP THRU
EDID MINDER
50Hz
AUDIO
DIGITAL
ANALOG 60Hz
1 2
C C A A J J D D E E F F I I G G F F B B K K
Figure 2. FOXBOX Tx Transmitter Connectors
A
HDMI Input connector (see below)
B
HDMI Loop-through Connector
C
Audio connector (see the next page )
D
RS-232 Over Fiber port
E
Alarm outputs port
F
Fiber optic connectors (see page 7 )
G
EDID Minder switch (see page 8 )
H
DIP switches
I
Configuration port
J
DC power connector
K
Indicators
A
HDMI Input connector (FOXBOX HDMI only) — Connect a single link of HDMI or
DVI-D (with the appropriate adapter) to this HDMI connector (see HDMI connector on
page 12).
The FOXBOX Tx HDMI also accepts embedded digital audio on this connector.
B
HDMI Loop-through connector — If desired, connect a local monitor to this HDMI
connector.