Extron electronics FOXBOX Rx HDMI, Руководство пользователя

Страница: 15 / 51

FOXBOX Tx/Rx HDMI • Installation 7
F
Fiber optic connectors and LEDs (see figure 2 on page 5)—
WARNING: The FOXBOX Tx/Rx HDMI outputs continuous invisible light,
which may be harmful to the eyes; use with caution.
AVERTISSEMENT : Le FOXBOX Tx/Rx HDMI émet une lumière invisible en
continu qui peut être dangereux pour les yeux, à utiliser avec précaution.
• Do not look into the rear panel fiber optic cable connectors or into the fiber
optic cables themselves.
• Ne regardez pas dans les connecteurs de câble fibre optique sur le panneau
arrière ou dans les câbles fibre optique eux-mêmes.
• Plug the attached dust caps into the optical transceivers when the fiber cable is
unplugged.
• Branchez les protections contre la poussière dans l’ensemble émetteur/
récepteur lorsque le câble fibre optique est débranché.
NOTES:
• Ensure that you use the proper fiber cable for your transmitter/receiver pair.
Typically, singlemode fiber has a yellow jacket and multimode cable has an
orange or aqua jacket.
• Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for video,
audio, and serial command transmission. But, if you connect only one fiber
optic cable, or if your receiver is configured to daisy-chain the optical signal:
• The HDMI signal output by the receiver is not HDCP-compliant.
• You will not receive RS-232 reports from the controlled device.
• To receive responses from the controlled device and for HDCP compliance,
you need to install both fiber optic cables and leave link 2 enabled (via an
SIS command (see page 25) to the receiver or using the FOX Extenders
Control Program (see page 34).
1
Tx (required)
— For all one-way video, audio, and serial
Transmitter
to
Receiver
OPTICAL
Rx Tx
LINK LINK
OPTICAL
Rx Tx
LINK LINK
1 1 2 2
communications from the transmitter to the receiver, connect a
fiber optic cable to the Tx LC connector.
Connect the free end of this fiber optic cable to the Rx connector
on the FOXBOX HDMI receiver (
item
Q
on figure 4 on page 10)
or to any other compatible Extron FOX device.
2
Rx (optional) — Connect a fiber optic cable for all one-way return
serial communications from the receiver to the transmitter.
Connect the free end of this fiber optic cable to the Tx connector
on a FOXBOX Rx HDMI receiver (
item
Q
on figure 4 on page 10)
or to any other compatible Extron FOX device.
Tx Link and Rx Link LEDs — When lit, the link is active (light is
received).