Set the speaker in place in the ceiling and position it so that the speaker edges are
hidden by the support rails or T-rails.
13.
If seismic support lines are being used, install them. See the illustration below.
NOTE:
Observe all applicable building codes and local ordinances when installing
the speaker.
Route the seismic line
through the line retainer
and bend-up tab.
Anchor this end to a
suitable secure point.
Seismic
Safety
Cable
Bend-up Tab
NOTE:
Repeated bending of the bend-up tab, as shown above, may cause the
tab to break off.
a.
Temporarily remove a ceiling tile adjacent to the speaker and set it aside.
b.
Connect a seismic support cable through the cable pass through loop, and attach
it to one of the seismic bend-up tabs located on either side of the speaker.
c.
Attach the other end of the cable to a sturdy part of the building (studs, roof
struts, and the like).
d.
For additional support lines repeat as needed.
e.
Replace the ceiling tile removed in step
13a
.
14.
Check all wiring before powering up the amplifier.
FF 220T Speakers • Installation
9