Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201 Rx, Руководство пользователя

Страница: 32 / 32

Extron USA - West
Headquarters
+ 800.633.9876
Inside USA/Canada Only
+1.714.491.1500
+1.714.491.1517
FAX
Extron USA - East
+800.633.9876
Inside USA/Canada Only
+1.919.863.1794
+1.919.863.1797
FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050
FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664
FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656
FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566
FAX
Extron Middle East
+971.4.2991800
+971.4.2991880
FAX
©
2010 Extron Electronics All rights reserved. www.extron.com
Installation Checklist
Determine which source will be used for the EDID information and configure the DDC
switches appropriately (
see pages 13 to 16)
. If necessary, use the EDID Minder to read and
store information from a display (
see pages 13 to 14
).
Prepare twisted pair cables ( see
“Terminating shielded cable”
).
Connect the transmitter to the receiver (
see “Connections”
)
Connect the source device to the transmitter ( see
“DVI-D input”
). Do not power on the
source device at this time.
Connect the display device to the receiver (
see “DVI-D output”
). If required, connect a local
monitor to the transmitter.
If required, connect any RS-232 or IR control devices ( see
“Control pass-through”
).
Connect the power supply to the transmitter (
see “Power input”
).
CAUTION:
Read all the Cautions in the
“Power Input”
section.
Power on the display device.
Power on and boot up the source device.