Extron electronics DTP2 R 212 Series, Руководство пользователя

Страница: 25 / 68

DTP2 R 212 Series • Installation 17
LockIt Lacing Brackets
Use the included LockIt lacing brackets to securely fasten the HDMI cables to each device
as follows.
1
Plug the HDMI cable into the rear panel connection.
2
Loosen the HDMI connection mounting screw from the
panel enough to allow the LockIt lacing bracket to be
placed over it. The screw does not have to be removed.
3
Place the LockIt lacing bracket on the screw and
against the HDMI connector, then tighten the screw to
secure the bracket.
ATTENTION:
• Do not overtighten the HDMI connector mounting
screw. The shield it fastens to is very thin and can
easily be stripped.
• Ne serrez pas trop la vis de montage du
connecteur HDMI. Le blindage auquel elle est
attachée est très fin et peut facilement être
dénudé.
4
Loosely place the included tie wrap around the HDMI
connector and the LockIt lacing bracket as shown.
3
1 1 1
2 2 2
3 3 3
4 4 4
5 5 5
5
While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length.