Extron DTP T HWP D and DTP T UWP D Series • Installation and Operation
12
Power Supply Wiring
NOTES:
•
Only one power supply is required for both the transmitter and receiver. A single
power supply connected to either unit in the pair powers both units.
•
A power supply is included with each individually-packaged transmitter.
•
Do not tin the power supply leads before installing them in the direct insertion
connector. Tinned wires are not as secure in the connectors and could be pulled
out.
Figure 10 shows how to wire the connector.
SECTION A–A
A
A
Power Supply
Captive Screw
Ridges
Smooth
3/16"
(5 mm) Max.
Connector
Output Cord
Figure 10.
Power Connector Wiring
CAUTION:
The wires must be kept separate while the power supply is plugged in.
Remove power before wiring.
ATTENTION :
Les deux cordons d’alimentation doivent être tenus à l’écart l’un de
l’autre quand l’alimentation est branchée. Couper l’alimentation avant de faire
l’installation électrique.
