Extron DTP T HWP D and DTP T UWP D Series • Introduction
2
DTP T HWP D and DTP T UWP D systems consist of a transmitter (Tx) and a receiver
(Rx). The transmitters and corresponding compatible receivers are sold separately. Each
purchased transmitter is shipped with a single external desktop 12 VDC power supply that
accepts 100 to 240 VAC, 50-60 Hz input. A single power supply connected to either the
transmitter or a compatible receiver can power both units through the twisted pair cable that
links the units.
Twisted Pair Cable Advantages
Twisted pair cable is much smaller, lighter, more flexible, and less expensive than coaxial
or HDMI cable. These transmitter and receiver twisted pair (TP) products make cable runs
simpler and less cumbersome. Termination of the cable with RJ-45 connectors is simple,
quick, and economical (see
Twisted Pair Recommendations for DTP Communication
on page 11 for more information).
NOTE:
Do
not
use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201
cable to link the transmitter and receiver. The DTP T HWP and UWP 232 and 332 do
not work properly with these cables.
Control Communications
The RS-232 or infrared (IR) communications are pass-through only. The transmitter and
receiver do not generate or respond to these signals.
Transmission Distance
The maximum transmission distance is determined by the resolution of the signal and the
twisted pair cable, graphics card, and display used in the system.
•
DTP T HWP and UWP 232 D
transmitters can transmit 720p, 1080i or 1080p HDTV
video signals up to 230 feet (70 meters) over STP cable.
•
DTP T HWP and UWP 332 D
transmitters can transmit 720p, 1080i or 1080p HDTV
video signals up to 330 feet (100 meters) over STP cable.
Features
Transmits HDMI signals over one STP cable (HWP models)
— Twisted pair cables
provide an economical, easily installed cable solution.
Transmits HDMI or VGA signals over one STP cable (UWP models)
— Twisted pair
cables provide an economical, easily installed cable solution.
Supports DDC and HDCP transmission
— The transmitters fully support long distance
transmission of the DDC and HDCP signals.
Control communications pass-through
— Bidirectional RS-232, IR, or both control
signals can be transmitted alongside the HDMI signal, so that the remote display can be
controlled without the need for additional cabling.
Analog stereo audio embedding
— Analog stereo audio signals can be selectively
embedded onto the digital video output signal and transported over DTP. The HDMI inputs
can be set to pass the embedded digital audio, embed the analog audio, or to automatically
embed the analog audio when no digital audio is detected.
External 100 VAC to 240 VAC, 50-60 Hz, international power supply
— Included with
transmitters.
Remote powering of the transmitter or receiver
— Only one power supply is necessary
to power both devices.
