Extron electronics DTP CrossPoint 4K Series, Руководство по установке

Страница: 14 / 44

6 DTP CrossPoint 4K Series • Installation
D
HDMI outputs
— Plug HDMI video displays (or DVI
with appropriate adapters) into these ports. See
HDMI
connectors to secure the connectors to the enclosure
with a LockIt HDMI Cable Lacing Bracket.
The following table identiies the HDMI outputs by matrix size.
Matrix Outputs Matrix Outputs
10x8 1, 2, 3, 4, 5A, 6A 8x6 1, 2, 3A, 4A
8x4 1, 2, 3A, 4A 8x2 1A, 2A
NOTE:
The signal output on the
n
A HDMI output (such as
5A) is duplicated on TP output
n
B (such as 5B).
E
TP (XTP/HDBT/DTP) switches
— XTP
DTP HDBT
ATTENTION:
•
Position this switch
BEFORE
connecting the
appropriate device to the TP connector. Failure
to comply can damage the endpoint.
•
Positionnez le sélecteur
AVANT
de connecter
l’appareil approprié au connecteur TP. Ne pas
respecter cette procédure pourrait endommager
le point de connexion.
The following table identiies the outputs with TP switches by
matrix size.
Matrix Outputs Matrix Outputs
10x8 5B, 6B, 7, 8 8x6 3B, 4B, 5, 6
8x4 3B, 4B 8x2 1B, 2B
XTP position — Select if the receiving device is an Extron
XTP matrix switcher. The TP output consists of HDMI with
embedded audio plus RS-232 and IR.
HDBT position
— Select if the receiving device is a
HDBaseT-enabled device. The TP output consists of HDMI with
embedded audio plus RS-232 and IR.
DTP position
— Select if the receiving device is an Extron DTP
device. The TP output consists of HDMI with embedded audio,
analog audio, RS-232 and IR, and remote power.
F
TP outputs — Plug compatible Extron DTP receivers,
SIG LINK
OUT
XTP matrix switchers, or HDBaseT-enabled devices
into these RJ-45 ports using TP cables. See
TP
connectors
on page 12 to wire the connector.
NOTE:
The signal output on the
n
B TP output (such as 5B)
is duplicated on HDMI output
n
A (such as 5A).