Extron electronics Digital Video Transmitter and Receiver HDMI 201 Tx/Rx, Руководство пользователя, Страница: 9 / 23

DVI 201 and HDMI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-6
DVI 201 and HDMI 201 Tx/Rx • Installation and Operation
2-7
5 . Slide the transmitter or receiver up and down in the
mounting brackets until the face of the transmitter or
receiver is at the desired height. Tighten the screws that
secure the brackets in place.
If the screws are inaccessible to a screwdriver:
a . Mark the location of the brackets relative to the screws.
b . Remove the transmitter or receiver from inside the
furniture.
c . Tighten the screws.
d . Replace the unit inside the surface (step 4 ).
Projector mounting
The receiver can be mounted on a projector bracket using either
of the following optional Extron projector mounting kits:
• PMK 300 projector mounting kit (part # 70-374-01 )
• PMK 350 low profi le projector mounting kit
(part #
70-563-02 [black] or part # 70-563-03 [white])
PMK 300 mounting
Mount the receiver to a PMK 300 bracket as follows:
1 . If necessary, remove the feet from the bottom of the
receiver.
2 . Mount the receiver to one of the bracket’s three mounting
plates using two of the supplied 4-40 x 3/16" screws in
opposite (diagonal) corners to secure the device to the
bracket. It can be vertically mounted facing either up or
down (fi gure 2-5).
N
On the side mounting plates, the device is typically
mounted on the outside of the bracket.
On the front mounting plate, the device is typically
mounted on the inside of the bracket.
3 . If power supply is connected to the receiver , use the two
included tie wraps to strap the power supply to one of the
brackets.
N
The PMK 300 has a hole in the bottom plate that
allows the projector pole to be inserted through the
center of the plate (fi gure 2-6), rather than outside of
the plate (fi gure 2-5). To install the PMK 300 in this
confi guration, slide the bracket up from the bottom of the
pole before the projector is installed on the pole.
4 . Place the contoured bracket base against the pole and
opposite the back plate. The pole should fi t snugly into the
depression in the center of the bracket base.
Extron
PMK 300
Multi-product Projector Mount Kit
U-Bolt
Front Mounting
PLate
Side Mounting
PLate
Extron
DVI 201
or HDMI 201
Receiver
Power Supply
Countoured
Bracket
Brace
Figure 2-5 — PMK 300 projector mounting a receiver
U-Bolt
Extron
PMK 300
Multi-product Projector
Mount Kit
Contoured
Bracket
Brace
Extron
DVI 201
or HDMI 201
Receiver
Power Supply
Figure 2-6 — Projector pole on the inside