Extron electronics Digital Video Transmitter and Receiver HDMI 201 Tx/Rx, Руководство пользователя, Страница: 12 / 23

DVI 201 and HDMI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-12
DVI 201 and HDMI 201 Tx/Rx • Installation and Operation
2-13
Receiver connections
The two transmitter models are in quarter-rack width
enclosures.
On the DVI 201 Rx (fi gure 2-11), the RS-232 Pass-Through
connector is on the front panel and the rest of the connectors are
on the rear panel.
DVI 200 Rx Series
POWER
12V
0.4A MAX
DVI 201 Rx
RS-232
PASS THRU
Tx Rx
1 2 DVI OUTPUT
8 9 10
Rear Panel
Front Panel
7
Figure 2-11 — DVI 201 Rx Receiver’s front and rear
panel connectors
On the HDMI 201 Rx (fi gure 2-12), all connectors are on rear
panel.
POWER
12V
0.4A MAX
1 2
HDMI OUTPUT RS-232
PASS THRU
Tx Rx
HDMI 201 Rx
8 11 7 9
Figure 2-12 — HDMI 201 Rx Receiver’s rear panel
connectors
g
RS-232 connector — Connect a serial communications port to
this 3.5 mm, 3-pole captive screw connector for bidirectional
RS-232 communication. See
RS-232 connector wiring , on
page 2-19 to wire the connector.
h
DC power input connector — Plug the included external
12 VDC power supply into either this 2-pole captive screw
connector or the power input connector on the transmitter
(item
d
on page 2-11). See Power supply wiring , on page 2-18, to
wire the connector.
i
Receiver input connector — Connect one end of the two
separate TP cables from the transmitter (item
e
on page 2-11) to
these RJ-45 female connectors.
C
Do not connect these devices to a computer data or
telecommunications network.
N
Connect transmitter output 1 to receiver input 1.
Connect transmitter output 2 to receiver input 2.
N
If necessary, test for proper cable connection (output 1 to
input 1, output 2 to input 2) as follows:
1. Plug both TP cables into the powered unit.
2 . Momentarily connect either of the cables on the
opposite end into the unpowered unit‘s “2” connector.
If the unpowered unit’s Power LED is lit , the
connection is correct.
If the unpowered unit’s Power LED is not lit ,
quickly unplug the connector on the unpowered end
and connect the other cable to the “2” connector.
See TP cable termination , on page 2-16, to properly wire the RJ-45
connectors.
j
DVI Output connector — Connect a DVI monitor or projector
for display of the transmitted direct digital image. See DVI
connector pin assignments on page 2-14 for pin assignments.
k
HDMI Output connector — Connect a HDMI monitor or
projector for display of the transmitted direct digital image.
See
HDMI connector pin assignments on page 2-15 for pin
assignments.