Extreme Networks ExtremeWare 7.0.0, Справочник по командам

Страница: 922 / 1598

922 ExtremeWare Software 7.0.0 Command Reference Guide
IGP Commands
config ospf timer
config ospf [vlan <vlan name> | area <area identifier> | virtual-link
<routerid> <area identifier>] timer <retransmit interval> <transit delay>
<hello interval> <dead interval> {<wait timer interval>}
Description
Configures the timers for one interface or all interfaces in the same OSPF area.
Syntax Description
Default
• retransmit interval—Default: 5
• transit delay—Default: 1
• hello interval—Default: 10
• dead interval—Default: 40
•
wait timer interval—Default: dead interval
Usage Guidelines
Configuring OSPF timers and authentication on a per-area basis is a shorthand for applying the timers
and authentication to each VLAN in the area at the time of configuration. If you add more VLANs to
the area, you must configure the timers and authentication for the new VLANs explicitly.
Example
The following command sets the timers on the virtual link in area 0.0.0.2:
config ospf virtual-link 6.6.6.6 0.0.0.2 timer 10 1 20 200
History
This command was available in ExtremeWare 2.0.
The syntax was modified in ExtremeWare 6.2.2.
vlan name Specifies a VLAN name.
area identifier Specifies an OSPF area.
routerid Specifies a router interface number.
retransmit interval Specifies a retransmit interval in seconds. The range is 0 - 3,600 seconds.
transit delay Specifies a transit delay in seconds. The range is 0 - 3,600 seconds.
hello interval Specifies the hello interval in seconds. The range is 1 - 65,535 seconds.
dead interval Specifies the dead interval in seconds. The range is 1 - 2,147,483,647
seconds.
wait timer interval Specifies the wait time in seconds.