Extreme Networks ExtremeWare 7.0.0, Справочник по командам

Страница: 730 / 1598

730 ExtremeWare Software 7.0.0 Command Reference Guide
STP Commands
show stpd
show stpd {detail | <spanning tree name>}
Description
Displays STPD settings on the switch.
Syntax Description
Default
N/A.
Usage Guidelines
The command displays the following STPD information:
• STPD name
• Bridge ID
• STPD configuration information
You must create, configure, and enable one or more STP domains before you can use the
show stpd
command. Use the
create stpd <name>
command to create an STP domain. If you have considerable
knowledge and experience with STP, you can configure the STPD using the
config stpd
commands.
However, the default STP parameters are adequate for most networks. Use the
create stpd <name>
command to create an STPD. Use the
enable stpd {<spanning tree name>}
command to enable an
STPD.
Example
The following command displays STPD settings on an STPD named Backbone_st:
show stpd backbone_st
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
detail Specifies that STPD settings should be shown for each STPD. (Version 6.2)
spanning tree name Specifies an STPD on the switch.